24/09/2012 12:21
I am in the midst of making a couple of HV power supplies. I would
like to know if there's a safe means of testing these under load,
without using the RF deck and an expensive tube to put a load on?
One supply is hopefully going to give about 3800V DC at about .8 of an
Amp, the other about 5kV at about 1.8 Amps. I would also like to be
able to load a transformer's AC output itself up to see how it reacts
under load. Has anyone "done this at home" and lived to share the
story? :) Thanks.
--
Best Regards,
Chris Wilson.
mailto: chris@chriswilson.tv
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|