I know of at least 2 on here that use a pair of 3-500's as a driver(-;
Carl
KM1H
----- Original Message -----
From: "Michael Clarson" <wv2zow@gmail.com>
To: <n2bc@stny.rr.com>
Cc: <amps@contesting.com>
Sent: Thursday, August 23, 2012 12:23 PM
Subject: Re: [Amps] Multiple Amplifier Switching Box
> N2BC: Not sure I understand why QSK would be an issue -- if your amp is in
> Standby, you should be able to run exciter through it, correct? You do
> have
> a point -- one needs to make sure IF series amps are tried, that the
> bypass
> around the amp can handle another amps full power and not just exciter
> power levels. --Mike, WV2ZOW
>
> On Thu, Aug 23, 2012 at 11:40 AM, N2BC <n2bc@stny.rr.com> wrote:
>
>> Amps in series.... not so good. I would guess that most QSK amps have
>> a
>> form of RF 'sniffer' on the input to prevent hot switching.
>>
>> Following a massive brain cramp, I cabled a KWS-1 (600W) through a TenTec
>> Titan. Was a bit confused when smoke started to curl out of the Titan &
>> it
>> was powered off. Result: charcoal grid circuit.
>>
>> -----Original Message-----
>>
>> Tessco ( www.tessco.com ) sells RG-400/U in one foot increments. If your
>> > amps have built in antenna relays, have you considered hooking your
>> > amps in series and just switching the PTT line? --
>>
>>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1424 / Virus Database: 2437/5219 - Release Date: 08/23/12
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|