EBM-Papst G2E108-AA05-44
Enough "oomph" to overcome normal chassis back pressure
and also push air around a 4-inch, 90-degree acoustic
sweep and out six feet of 4-inch hose. Cast aluminum
housing, roughly 77 CFM at 0.41 inches of water.
54 dB A-weighted, less when installed correctly and both
intake and exhaust are properly treated.
Available from Newark, OnlineComponents.com, Allied, etc.
(requires 4uF capacitor and finger screen, not included)
73,
Jim N7CXI
On 8/7/2012 5:08 PM, Bruce Osterberg wrote:
> Since you Asked Specifically for an 8877 Tube and a Part number for a
> Blower for that Tube, Here is My Recommendation and What I use on My
> W6PO Amplifier, That I use Key Down on EME with WSJT for a 60 Second
> Time Period:
>
> FASCO NO 702111713 Type U21B RPM 3030
> 1/25 HP .49 Amps at 115 Volts Part Number 25-7615
>
> 73 Bruce N9BX 73
>
> On 8/7/2012 3:14 PM, Peter Voelpel wrote:
>> Hi Charles,
>>
>> The EBM-Papst model G2E085-AA01-01 will be sufficient for the 8877.
>> Of course, any blower will cause more noise then a fan.
>> If the tube is not run at full dissipation you can always reduce the blower
>> voltage and by that the noise level.
>> I use the G2E085 with 3x3CX800A7.
>>
>> 73
>> Peter, DJ7WW
>>
>> -----Original Message-----
>> From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
>> Behalf Of Charles Bibb
>> Sent: Dienstag, 7. August 2012 21:53
>> To: amps@contesting.com
>> Subject: [Amps] Blower recommendations 8877 amp.
>>
>>
>> I'm looking for specific blower recommendations for a HB 8877 amp.
>> (blower maker and model #).
>>
>> Everyone says use a Papst blower because they are quieter. I use a Papst
>> fan in my HB 2x3-500 amp.
>>
>> I have several blowers here. The ones that obviously move enough air are WAY
>> too loud! The quiet ones I'm not sure about. They seem to move plenty of
>> air, but don't produce the amount of water level change recommended by
>> Eimac.
>>
>> I built a liquid tube manometer gauge to measure the back pressure. Only
>> the loudest can deliver the minimum 0.41 inch change in water level that
>> Eimac recommends for the 8877. Surely, there are compromises that work just
>> fine.
>>
>> What blower are you guys using in your single 8877 amps? Recommendations,
>> anyone?
>>
>> 73,
>> Charles - K5ZK
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|