Amps
[Top] [All Lists]

Re: [Amps] Overdrive protection

To: amps@contesting.com
Subject: Re: [Amps] Overdrive protection
From: <jhurry@austin.rr.com>
Date: Sat, 28 Jul 2012 17:52:19 +0000
List-post: <amps@contesting.com">mailto:amps@contesting.com>
A properly designed amp should be able to take care of itself.  ALC is a ham 
carry over from when there were no Drive controls, so the ALC was used to bring 
down the power in the Swan/Galaxy days to keep from burning up the sweep tubes 
in the amps.  Some of the resent solid state amps have relied on alc to protect 
their poor designs.  The good amps, like the SGC 500 takes care of itself 
internally.   Running all the controls to the right is not only poor operation 
habits, but a poorly setup ALC can generate a worse signal on the bands as a 
poorly tuned amp, and still be just as tough on the tubes.   Best to not use it 
and tune the station properly in the first place.  Many times "overshoot" is a 
result of some gain set too high,  be it mic, drive, alc, compression,  or not 
enough delay from keyup to RF output.  I've seen some radios, just disconnect 
the mic and any overshoot goes away.   

Dudley
WA5QPZ
_______________________________________________
Amps mailing list
http://lists.contesting.com/mailman/listinfo/amps


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>