My Icom 7600, 751A and IC7200 don’t have the problem. The Kenwood TS-830S on
the other hand.... 150+ watts on first keyup.
73
Jim W7RY
-----Original Message-----
From: Joe Subich, W4TV
Sent: Thursday, July 26, 2012 12:11 PM
To: amps@contesting.com
Subject: Re: [Amps] Overdrive protection
> My question -- and maybe there's an Alpha employee on the list who
> wants to answer -- is "isn't it possible to make an overdrive
> protection circuit that will cause the amplifier to fault fast enough
> to protect the tubes and components?"
Of course there is but such a protection circuit would make the amp
almost impossible to use with the many rigs have have a horrendous ALC
spike on initial key-down. Many of the most commonly used rigs produce
a full power (or higher) 2-5 ms long even when cranked back to 30 or
40 watts.
73,
... Joe, W4TV
On 7/26/2012 12:36 PM, Vic K2VCO wrote:
> Alpha's email newsletter talks about damage to amplifiers as a result of
> overdrive -- the
> example is given of amplifiers designed to produce 1500w output with 40w
> drive being
> driven with 150w. They say that there is a log maintained by the firmware
> which records
> overdrive incidents and that they won't repair damage caused by this kind
> of abuse under
> warranty.
>
> I am sympathetic to their attitude and don't approve of the philosophy
> that all knobs
> should always be set to 11. But sometimes it's unintentional.
>
> My question -- and maybe there's an Alpha employee on the list who wants
> to answer -- is
> "isn't it possible to make an overdrive protection circuit that will cause
> the amplifier
> to fault fast enough to protect the tubes and components?"
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|