If the wire is Teflon it will probably be fine. Can you tell if it is?
In a message dated 7/8/2012 1:01:03 P.M. Eastern Daylight Time,
n4kwpete@centurylink.net writes:
I ordered a filament transformer for a 4CX1500B linear that I am building.
When I received the transformer all looked great to me except for the
secondary pigtail wires. The tube requires 6vac at 10amps, the pigtails
provided are about five inches long and are a #18 well insulated wire.
Being concerned with the wire size it put the transformer under load and
drawing 10amps left it that way for about an hour. The wire did not over
heat in that time but hey how about hours of operating. Should I be
concerned with the wire size. I have looked for information on how to
figure how much current various wire sizes can carry and at various
voltages
and have not found anything.
73 Pete N4KW
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|