I can give reviews of that kit since I built and tested it for Ian in my 6M
NCL-2000 as far back as pre production in the 90's and have built many more
for stock and 6M converted NCL-2000's, various Johnson's including the 6n2
T-Bolt and other tetrode amps.
IMD testing has shown a solid 3-5dB improvement with some a bit more and
that was without cherry picking the audio frequencies as does the ARRL.
It is easy to assemble, instructions are superb and it works as advertised.
I highly recommend it AND I have no financial interest in it.
Carl
KM1H
----- Original Message -----
From: "Gene May" <gene-may@hotmail.com>
To: "Amplifier Mailing List" <amps@contesting.com>
Sent: Tuesday, April 03, 2012 6:05 PM
Subject: [Amps] Power supplies for tetrode screen grids and G3SEK's kit
>
> While following this thread, I read of G3SEK's kit for this purpose. It
> is well documented on-line -- see www.ifwtech.co.uk/g3sek/ -- and an
> article he published in QEX that summarizes much of what has been in the
> thread is available . Even though I had already bought many of the parts
> necessary to "do this right", his write-ups seemed that he had covered the
> problems and requirements well, so I ordered one of the kits. It seemed
> that he mailed it within 12 hours of his receiving it, and it came
> quickly. It is reasonably priced, has parts from good manufacturers, and
> the PCB are well made.
>
> I haven't assembled and tested it yet, and when I do so, will write it up
> for this reflector.
>
> Gene May
> WB8WKU
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1424 / Virus Database: 2113/4913 - Release Date: 04/03/12
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|