While following this thread, I read of G3SEK's kit for this purpose. It is
well documented on-line -- see www.ifwtech.co.uk/g3sek/ -- and an article he
published in QEX that summarizes much of what has been in the thread is
available . Even though I had already bought many of the parts necessary to
"do this right", his write-ups seemed that he had covered the problems and
requirements well, so I ordered one of the kits. It seemed that he mailed it
within 12 hours of his receiving it, and it came quickly. It is reasonably
priced, has parts from good manufacturers, and the PCB are well made.
I haven't assembled and tested it yet, and when I do so, will write it up for
this reflector.
Gene May
WB8WKU
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|