----- Original Message -----
From: "Mike Tubby" <mike@tubby.org>
To: "David Shapiro" <info@transmittersrus.com>
Cc: "'Carl'" <km1h@jeremy.mv.com>; <amps@contesting.com>
Sent: Sunday, March 11, 2012 5:06 AM
Subject: Re: [Amps] 6kW Coax
> Dave,
>
> Some thoughts:
>
> 1. your design really should be a full Wilkinson combiner, the output of
> each LPF should have a 100R across to the output of the other LPF so that
> you have circa 30dB of isolation between the transmitters - consider what
> happens if of half fails
>
> 2. you "coax 70-75 ohms" needs to be 70.71 ohms of the system is matched
> to 50R with a decent return loss
>
> 3. at the power levels you're aiming for any loss of very important...
> recall that 0.1dB loss is 11% and at your power levels that's a lot of
> heat
HUH? Better check that math.
Carl
KM1H
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|