I look forward to seeing some more photos of your magnificent workmanship,
Bob.
73
Dave G0OIL
----- Original Message -----
From: "Robert Briggs" <vk3zl@bigpond.com>
To: <amps@contesting.com>
Sent: Tuesday, October 18, 2011 9:11 AM
Subject: [Amps] Anodised aluminum
>
>
> I would like to thank you all for the helpful replies and emails
> regarding using anodised aluminum in amplfier boxes...
>
> The consensus is that it is quite ok to use provided bolts and rivets
> bond clean aluminum surfaces...
>
> The material I obtained (free) is 2mm thick and heavily anodised on both
> sides..The anodising is nearly like a ceramic coating and virtually
> scratch proof....I am going to make a 6 meter GS-35B amplifier using
> this material for the case...It has a really nice satin grey finish..I
> have just made up a special tool to remove the anodising from all the
> drill holes exposing the bare aluminum...
>
> I must tell you, the VHF/SHF fraternity here told me that anodised
> aluminum is a big NO for rf work...It takes me three days to manufacture
> amplifier cases in my workshop so I look forward to the outcome...
>
> 73...Bob..VK3ZL..
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|