Hi Bob - I don't see why not. If you put screws or rivets through the case
joints every inch or so, I'd argue that you could probably do without
removing the anodising at all. However I know that you like to build things
just right :-)
cheers
Dave G0OIL
----- Original Message -----
From: "Robert Briggs" <vk3zl@bigpond.com>
To: <amps@contesting.com>
Sent: Monday, October 17, 2011 11:53 AM
Subject: [Amps] Anodised aluminum
>
>
> Hi all...I have just aquired a quantity of 2mm anodised aluminum sheet,,
> I am wondering if I remove the anodising from all contact surfaces if I
> can use this stock for rf deck cases...
>
> Cheers all....Bob..VK3ZL..
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|