I believe their normal customers are CB'ers building high power solid state 27
MHz amplifiers.
Look at their products. The power combiners don't even have a frequency spec.
Most likely
for 27 MHz use. They sell SS amplifer kits up to many kW.
73
Bill wa4lav
________________________________________
From: amps-bounces@contesting.com [amps-bounces@contesting.com] On Behalf Of
Carey Lockhart [kc5gtt@gmail.com]
Sent: Friday, June 10, 2011 1:17 PM
To: Wt8r@aol.com; amps@contesting.com
Subject: Re: [Amps] Amp Chassis
i have been getting may cases at
http://icamanufacturing.homestead.com/ACCabinets.html. but there are a few
pieces i still have to make which is really time consuming. plus machine cut
pieces are so much cleaner. i have a metal break and metal tools just no
patience
Carey
On Fri, Jun 10, 2011 at 10:59 AM, <Wt8r@aol.com> wrote:
> In a message dated 6/9/2011 9:36:22 PM Central Daylight Time,
> kc5gtt@gmail.com writes:
>
> I am looking for a reasonable priced sheet metal shop. i need some of my
> chassis parts made. also would like to get the plate lines jet cut. shure
> would save me time.
>
> Carey
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting
>
>
> IF YOU GET SOME REASONABLE REPLIES, I WOULD APPRECIATE YOU FORWARDING THEM
> TO ME.
>
> 73 DE
>
> DAVE, WT8R
>
--
Carey Lockhart, KC5GTT
Boerne, Tx. 78006
www.kc5gtt.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|