| To: | <amps@contesting.com> |
|---|---|
| Subject: | [Amps] Amp Chassis |
| From: | "Carey Lockhart, KC5GTT" <kc5gtt@gmail.com> |
| Date: | Thu, 9 Jun 2011 21:36:02 -0500 |
| List-post: | <amps@contesting.com">mailto:amps@contesting.com> |
i am looking for a reasonable priced sheet metal shop. i need some of my chassis parts made. also would like to get the plate lines jet cut. shure would save me time. Carey _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Amps] Dummy load varying R, Roger (sub1) |
|---|---|
| Next by Date: | [Amps] 70cm amp, Paul Decker |
| Previous by Thread: | [Amps] RF choke switching, Vic K2VCO |
| Next by Thread: | Re: [Amps] Amp Chassis, Jim W7RY |
| Indexes: | [Date] [Thread] [Top] [All Lists] |