Recently replaced the 4 811 tubes in my AL-811H with a matched quad.
I replaced them because, upon turning the amp on a while back I heard a loud
POP and the amp went dead.
The fuse blew. Replaced Fuse -- same result.
Spoke to some amp gurus around here and said the tubes were probably
shorting out as they were bad - - replace. So I did.
Now when I turn on the rig and tune up I am apparently getting RF into the
AMP as the plate and grid meters move and behave as expected through the
tuneup
procedures. However, I show no power out whatsoever from the amp.
Any ideas what to check next? I'm thinking I blew another component
somewhere and plan to take the cover off to see if the smoke has been let
out of anything.
Thanks,
Chuck
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|