Have you checked the obvious...the On/Off switch?
Carl
KM1H
----- Original Message -----
From: "k9sd" <k9sd@ezl.com>
To: <amps@contesting.com>
Sent: Thursday, December 10, 2009 3:16 PM
Subject: [Amps] Alpha 76 problem
> When the amp is first plugged in and before the power switch is thrown the
> power comes on..the blower runs
> There was a bad tube which caused the inrush resistor 20 ohm at 25 watts
> to burn out...I have replaced it ..
>
> I have removed all the tubes
>
> When I plug the amplifier in I can see that K1 relay closes...that is
> before the power switch is thrown..
>
>
> I hope someone has had this problem before and could save me time...
>
>
> Thanks for any help..
>
>
>
> also if anyone has any parts for a Harris RF-3230 amplifier let me know
> (mine works perfect just thinking ahead )...or If anyone is using
> one...always looking for
> new folks that use them..
>
>
>
> Sam K9SD
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|