As long as you are sure about the dissipation rating that you need, then one
taking a little more than the other is fine. Expect +/-5% tolerance on each
part and an additional change with temperature, which will be less than
using a single part. You will improve the reliability. What are your
circuit conditions? You can take this off list if you wish.
David
G3UNA
> OK David, this may sound a dumbo question, but...
>
> I then take it that it's OK to series the 62v and the 47v to give me 109v
> then?
>
> For various reasons my project has been over 8 years in the making, but
> it's
> so close now I can almost taste the RF :-)
>
> 73 Andy
> http://www.gd0tep.com
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|