I mistyped ... I had a (FIVE) 5CX1500B running 5KV at .6 amps for years.
Don WA4NPL
Quoting Carl <km1h@jeremy.mv.com>:
> I dont think so Don, thats a bit over 7KV DC. Just right for a 4X1
> in full bloom (-;
>
> Carl
> KM1H
>
>
> ----- Original Message ----- From: <donroden@hiwaay.net>
> To: <amps@contesting.com>
> Sent: Monday, October 19, 2009 10:13 AM
> Subject: Re: [Amps] Peter Dahl XFMR question (I Have one!)
>
>
>>
>>
>> In commercial service, the 5KV tap would work for a single 4CX1500B.
>> (and running 208vac the 6kv tap might be used )
>>
>> Don WA4NPL
>>
>>
>> Quoting "Van K7VS" <wa7fab@cdsnet.net>:
>>
>>
>> [Hide Quoted Text]
>> My Goodness! I just picked up a new old stock Peter Dahl XFMR. Based on
>> what I know, it probably was built around 2002-or 3. It is tapped to
>> supply 3KV, 4KV, 5KV and 6KV at .9 amps. The input side give one a choice
>> of either 220 or 240V. It came from a fellow ham. What in gods green acre
>> would one want something this size for?? And what would a replacement from
>> them cost today for curiousity sake. Van, K7VS
>>
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|