Use the 3CX800A7 data sheet. The minor internal differences will have no
effect in anamp except for a very slight tuning difference on 10 or 6M
Carl
KM1H
----- Original Message -----
From: "Charles Bibb" <zedkay@telepak.net>
To: <amps@contesting.com>
Sent: Wednesday, February 11, 2009 10:36 AM
Subject: [Amps] 3CPX800A7
>
> Need a little info guys:
>
> I found the data sheet for the 3CPX800A7 at the CPI/Eimac website,
> but this data sheet looks as though a few things have been left
> off. They say the tube is "intended for use in zero bias class B
> amplifiers in pulsed radio frequency applications".
>
> However, if I were using it in a grounded grid application, would I
> not bias it? I don't see any data on bias voltage. What is typical?
> and what should the zero-signal (idle) anode current be? Also, what
> is the typical maximum grid current?
>
> My first homebrewed amp (now sitting on the shelf) used a single
> 3-500. The HV supply transformer loafed along with one 3-500, so I'm
> thinking of a conversion to this tube with not than many
> modifications.
>
> Can anyone point me in the right direction for more detailed specs on
> this tube?
>
> TIA,
>
> Charles - K5ZK
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|