My homebrew amp has 3 compartments - the RF compartment, an under-chassis
compartment for the input and control circuitry, and a front subpanel area for
metering and control knobs and switches.
What is the preferred method for routing control leads from the under-chassis
compartment out through the subpanel to the various meters/knobs/switches. A
grommetted hole with bypass caps on the inside? Feed-thru caps?
The Orr handbook (23rd ed. p.12-10) has a comparison diagram of various lead
filtering setups. The most bang-for-buck appearing to be a single .01uF
Sprague hi-pass feedthru cap.
Steve KK7UV
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|