I don't think so, Charlie. The filament AC voltage given by the manufacturer's
is the 'AC RMS' value and hence is (given no distortion in the AC waveform)
identical to the DC value. Bottom line: the two values should be the same.
73
Bob, WA2CKY
________________________________
From: Missouri Guy <n0tt1@juno.com>
To: amps@contesting.com
Sent: Monday, January 26, 2009 10:09:38 AM
Subject: Re: [Amps] Regulated DC heater
Hi Gents,
Just for some future info here....If I use regulated DC to power
the filaments on any tube, and let's say the required voltage is
5 volts AC, shouldn't (or couldn't) the
DC value be 5 x .707= ~3.54 VDC?
Thanks,
Charlie, N0TT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|