Amps
[Top] [All Lists]

Re: [Amps] Plate choke resonanse and safe operation

To: "Carl" <km1h@jeremy.mv.com>, <amps@contesting.com>
Subject: Re: [Amps] Plate choke resonanse and safe operation
From: "OZ1AXG Flam" <oz1axg.nospam@dxmail.dk>
Date: Sun, 7 Dec 2008 12:06:15 +0100
List-post: <amps@contesting.com">mailto:amps@contesting.com>
the RFC is Installed

I will try to measure the resonans again. For 27 MHZ i did the measurement 3 
times. A grid dip meter is not the most accurate instrument, so i will try 
it again. but how close is "safe" ? what would the symptoms be at tuneup if 
resonans is close by ?

Then old RFC fried (broke a wire) when i accendential tranmitted 125 watt 
(1/2 second) in the amplifier. Had forgotten to reduce the drive before 
tuning :=(  This has happened before on other band - but this was a first 
for 30 meters ...

OZ1AXG Flam

----- Original Message ----- 
From: "Carl" <km1h@jeremy.mv.com>


> Is that installed or on the bench? That first one is too close for
> comfort for 10M CW.



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>