Adrian Rees (MW1LCR) wrote:
> Hi all
>
> Does anyone know of a piece of software that I can use to calculate /
> design inductors. (Specifically the gauge of conductor is the issue, as
> I plan on using 6 or 8 mm diameter copper pipe). The inductors will be
> carrying High Voltage, and a typical example of use will be a matching
> unit for a Bob Tail Curtain.
>
> Replies off list please.
>
This it the kind of thing I'd like to see on the reflector.
Roger (K8RI)
> Apologies for the bandwidth.
>
> Regards
>
> Adrian MW1LCR
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|