In a message dated 11/30/2008 10:11:39 A.M. Eastern Standard Time,
w5kp@hughes.net writes:
I have a question about the other end of an amp. I don't own a monitor,
but could an MFJ-259 be used to tweak the bandswitched input tuning
coils of an AL-811 by sweeping the input (while keeping the keying relay
manually closed)?
Jerry W5KP
The best way is to set the amp up into a dummy load with an swr in between
the rig and input of amp, and adjust the input coils for low SWR while
transmitting. There Al-811 amp comes factory set and if it needs any
adjustment,
should be very little. Doing a static adjustment with a MFJ, may get close,
it
won't be as exact as doing it while actually transmitting. Lou
**************Life should be easier. So should your homepage. Try the NEW
AOL.com.
(http://www.aol.com/?optin=new-dp&icid=aolcom40vanity&ncid=emlcntaolcom00000002)
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|