No one said they have to be round. I used 1/2" square stock, cut off an
inch, drilled a 1/4" hole, tapped for the 6-32 screws.
Glen Zook wrote:
> Frankly, you can make you own couplers for just a few cents each from copper
> tubing that has an inside diameter of 1/4 inch. Cut off a length about 1
> inch long and then drill a hole near each end. Then "tap" that hole for a
> machine screw.
>
> Now you will need a tubing cutter which is just a few dollars at any home
> improvement center, a drill and bit, and a tap. However, these tools are
> already in the possession of just about any amateur radio operator who does
> any building at all.
>
> Glen, K9STH
>
> Website: http://k9sth.com
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|