you know, guys,
I was kinda surprised that I was able to fry the switch in 200W-rated tuner
using only 100W RF. Geez, I did it in 5 nimutes :)
Speaking of replacement - I found Lorlin CK1458 at mouser.com website. it is
250V or 15A rated, I hope it will work better than the dead one.
Is there any alternative place to look for rotary switches and possibly
variable capacitors/inductors?
2007/8/30, Tom Rauch <w8ji@contesting.com>:
>
> >
> > Aren't these switches known as "Make-Before-Break" and
> > "Break-Before-Make".
>
>
> Yes, that's another name in technical descriptions. In
> catalogs and by manufacturers (at least on this side of the
> pond) they are more commonly called "shorting" and
> "non-shorting" rather than the "make before break".
>
> For example Centralab uses "shorting" to describe a "make
> before break" contact. Non-shorting is used in their
> catalogs to describe "break before make".
>
> Amp Supply was big on ordering the wrong switch. What they
> wanted was "pick up and hold" design but with "non-shorting"
> contacts. What they always seemed to order was a "shorting"
> switch.
>
> You have to be very careful to look at what the manufacturer
> does, but in general (at least in the USA) the term
> "shorting" means make before break. That generally means the
> switch has much lower contact to contact voltage holdoff on
> adjacent contacts.
>
> 73 Tom
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|