In a message dated 8/21/2007 4:01:47 P.M. Eastern Daylight Time,
ok1dxd@seznam.cz writes:
Dear all,
just have bought from RF Parts two new 3-500ZG for my lovely TL922. I wil
be very grateful, if any of group here could to advice me some userful
information how-to bring them to the service without any troubles...
73 de Tomas, OK1DXD
I have used RF parts tubes many time, I just put them in the amp and let
them warm up a couple minutes and go for it. I don't think there is any
protocol in getting them going, but I guess if you want to cook the filaments
for
30 minutes before applying RF won't hurt. 73 Lou
************************************** Get a sneak peek of the all-new AOL at
http://discover.aol.com/memed/aolcom30tour
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|