I understand what your`e saying...Iv`e done it that way many times too,what
I want to do is run a balanced input drawing equal current from both legs of
the 240v ac mains as well as isolating the rf deck primary from the
hvps..Jim K7RDX...
----- Original Message -----
From: "jeremy-ca" <km1h@jeremy.mv.com>
To: "k7rdx" <k7rdx@charter.net>; "Amps Amps" <amps@contesting.com>
Sent: Sunday, July 08, 2007 7:43 AM
Subject: Re: [Amps] Transformer question
> Maybe Im a little dense but I have no idea what you are asking.
> If the plate transformer runs on 240 and the rest on 120 you do not need a
> separate 120 line. Simply use one leg of the 240 line against the neutral.
> Real old 220 lines and EU stuff uses a 2 wire setup; its 3 wire in the
USA.
>
> Carl
> KM1H
>
>
> ----- Original Message -----
> From: "k7rdx" <k7rdx@charter.net>
> To: "Amps Amps" <amps@contesting.com>
> Sent: Saturday, July 07, 2007 11:09 PM
> Subject: [Amps] Transformer question
>
>
> >I have a 2kva isolation/240-120 step down transformer I want to use to
> >power
> > a rf deck with 120v filament transformer&blower. Is it necessary to
switch
> > the 240 primary or can the primary be hooked directly to the ac mains
thru
> > fuses?Thanks in advance for your input..Jim K7RDX..
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|