I just noticed that you do not have a manual for the amp. You can use your
voltmeter to measure the voltage between the amp relay connector and ground
to see what the relay coil voltage is. 73, Dan
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com]On
Behalf Of TROY D SINGLETON
Sent: Sunday, July 01, 2007 9:34 AM
To: AMPS@CONTESTING.COM
Subject: [Amps] Dentron 1200L
Hello,
First of all let me say I have never owned a amp before now. I never thought
I needed one. I purchased a Dentron 1200-L Off of ebay a few weeks back. The
problem I am having is how to hook the amp up. I know this sounds stupid but
I dont have a manual or anything for this amp. I hooked the coax cables up
and selected the band and set the load to 3. I sent out a CW tone and tried
tuning the thing but nothing on the meter changed. The plate voltage still
says 1800 and any selector I change nothing happens. When I got to transmitt
there is no clicking in the amp or anything. I dont have a power meter at
this time but I dont think nothing is going out of the amp. Do I need to
hook anyhting else up..Relay-Alc? I am as lost as a goose in a snow storm. I
am tring to run this amp with a kenwood 570D. Any help would be much
apreciated. I am diasabled and not able to lift this amp around much to work
on it. So that makes things even more difficult. If I do remove the top
cover what should I look for and or test.
Thanks
N5ARK
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|