Amps
[Top] [All Lists]

Re: [Amps] Replacing oil in a Bird load

To: "Jim Hoge" <knowkode@sbcglobal.net>,"amp reflector" <amps@contesting.com>
Subject: Re: [Amps] Replacing oil in a Bird load
From: "jeremy-ca" <km1h@jeremy.mv.com>
Date: Thu, 7 Jun 2007 20:08:45 -0400
List-post: <mailto:amps@contesting.com>
Tnx for the info on Diala Jim; I'll try and find a source of a few gallons 
of AX tmw. The resistor is fine with a RL of 27dB at 1296. This was a 
special build for RCA back in the LPTV days and was spec'ed at 470-910 mHz; 
I use it from 1.8 to 1296.

Carl
KM1H



----- Original Message ----- 
From: "Jim Hoge" <knowkode@sbcglobal.net>
To: "amp reflector" <amps@contesting.com>
Sent: Thursday, June 07, 2007 11:16 AM
Subject: Re: [Amps] Replacing oil in a Bird load


> Shell Diala is the oil of choice. A LOT cheaper than Bird's replacement 
> oil and juist as effective if not better. Yes, the oil can "wear out," 
> most commonly by becoming contaminated by humidity. Remember, the load has 
> a vent cap. A burnt smell would also cause me concern for the resistor. Do 
> you have an antenna analyzer you can use to sweep the load?
>
>  Jim W5QM
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>