Flaring tool for tubing or maybe a minature version of
the common exhaust pipe expander.
Mike k1ern
----- Original Message -----
From: "mike kendall" <ke6cvh@yahoo.com>
To: <amps@contesting.com>
Sent: Friday, August 11, 2006 12:33 PM
Subject: [Amps] Mechanical question
Hello all,
I recieved the cold plate (liquid cooling plate that attaches to the heat
spreader) in for the linear project I'm
working on. It has 1/8 inch copper tubing coming out of it for a couple inches
and is designed to have more copper
brake line soldered/brazed to it. Is there a tool that I could use to expand
out the brake line a little so it will
slip over the other brake line and allow a good mechanical connection before
soldering?
73,
Mike
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|