Copper and brass are extremely difficult to dtill with conventional drill
bits. The drill will grab and possibly break. It may even lift the drill
press vise up. Very dangerous. Machinists grind the drill for such a job so
that the angle of the forward cutting edge is less than usual. I would wrap
a spiral of tinned buss wire around the smaller tubing for a snug fit, then
solder it.73, Dan, N5AR
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com]On
Behalf Of mike kendall
Sent: Friday, August 11, 2006 10:25 AM
To: amps@contesting.com
Subject: Re: [Amps] Mechanical question
Colin,
I was wondering if there is a "next size larger tubing" that will fit
over it like telescoping aluminum tubing for antennas. If there is that
would be the easiest approach for sure. Possibly, if there is not an easier
next size up of tubing I could get a small bit of copper and use a drill
press to drill it out with the right bit then slip it over and solder. I
would have to heat it up before sliding it over to try to keep the heat
stress off the cold plate.
73,
Mike
Colin Lamb <k7fm@teleport.com> wrote:
Hi Mike:
Always trying to do things with the least amount of work, what about using a
coupling that is simply one size larger, then solder onto both lines. That
requires no swaging, only a little more solder, less expense and less work.
73, Colin K7FM
-----Original Message-----
>From: mike kendall
>Sent: Aug 11, 2006 9:33 AM
>To: amps@contesting.com
>Subject: [Amps] Mechanical question
>
>Hello all,
> I recieved the cold plate (liquid cooling plate that attaches to the heat
spreader) in for the linear project I'm working on. It has 1/8 inch copper
tubing coming out of it for a couple inches and is designed to have more
copper brake line soldered/brazed to it. Is there a tool that I could use to
expand out the brake line a little so it will slip over the other brake line
and allow a good mechanical connection before soldering?
> 73,
> Mike
>
>
>---------------------------------
>Talk is cheap. Use Yahoo! Messenger to make PC-to-Phone calls. Great rates
starting at 1¢/min.
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
---------------------------------
How low will we go? Check out Yahoo! Messenger?s low PC-to-Phone call
rates.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.405 / Virus Database: 268.10.9/416 - Release Date: 8/10/2006
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|