Amps
[Top] [All Lists]

Re: [Amps] PIN diode mods

Subject: Re: [Amps] PIN diode mods
From: Jan Erik Holm <sm2ekm@telia.com>
Date: Wed, 26 Jul 2006 12:48:07 +0200
List-post: <mailto:amps@contesting.com>
Then FT-1000D is a low end radio!
2nd order IMD improves over 20 dB when doing
PIN diode mod.
By the same time IMDDR3 2 kHz spaceing improves
approx 15 dB.
Voodoo....yeah right!

73 SM2EKM
---------------------------

Craig wrote:
> Most of the early PIN diode mods came from the information and articles 
> by Ulrich Rohde  N1UL.
> 
> The PIN diode mods were mostly for 2nd order  IMD  problems. There were 
> claims for  some minor improvements in blocking and 3rd order dynamic 
> range. However i seem recall most of the mods applied to low end radios 
> like the TS450 and TS50 which suffered  badly from  2nd  order IMD  in 
> places like Europe. I also seem to recall  that Signal One started 
> promoting the supposed advantages of the HP PIN diodes in the Mil 
> Packaged IC-781.
> 
>  Maybe  Ulrich with his well respected HF credentials and his vast 
> experience with collocated HF transmitters and receivers in military 
> markets became  the main   focus   for all his  measured  improvements.  
> The data measured  with very  wide spaced high 3rd order intercept 
> points may be valid using  better PIN diodes in  such a severe RF 
> environments. Only he could answer these questions.
> 
> 
> Craig
> VK3HE
>

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>