From: Jeff Strailey <liveccam@yahoo.com>
> I recently obtained an Amp Supply LK-500ZB. The first order of business was
> the
> conversion to 120 volt operation. When the amp is powered plate voltage as
> measured by the internal meter is about 1500 volts instead of the 3100-3300
> vdc
I once bought a used SB-220 that had been "converted" to a full-wave bridge
rectifier instead of the full-wave voltage doubler supplied by Heathkit.
NOTE: I sure would try to run that amp off 240 V, not 120.
73,
Jim, KR1S
http://kr1s.kearman.com/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|