Jim Kearman escribió:
> This is worth restating for first-time amp builders: Check the break-down
> voltage rating of the resistors you plan to use for bleeders. Most
> resistors capable of dissipating the wattage will withstand 400 V, but read
> the datasheets. Surplus components with unknown specs are a big risk. You
Is there any procedure to test them, if no datasheet is available?.
Best regards
Guillermo - LU8EYW.
> definitely want some headroom for components that get hot, and that are
> installed in a confined space. A HVPS is not the place to cut corners.
>
> 73,
>
> Jim, KR1S http://kr1s.kearman.com/
> _______________________________________________ Amps mailing list
> Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|