Amps
[Top] [All Lists]

[Amps] wide band amplifier ??

To: amps <amps@contesting.com>
Subject: [Amps] wide band amplifier ??
From: Dan Sawyer <dansawyer@earthlink.net>
Date: Wed, 08 Mar 2006 19:53:40 -0800
List-post: <mailto:amps@contesting.com>
All,

This question is regards to a 3 to 30 MHz 'driver amp' in an SB104. If I 
disconnect the input from the driver amp and examine it, the input is 
clean. However when the input is connected to the driver it appears as 
though there is feedback from the amp into the input circuit at some 
frequencies. The driver amp itself is a push-pull grounded emitter NPN 
configuration. 

The driver amp output is not consistent across the band. At the high end 
and at the low end the amp seems fine. However in the middle the output 
is clipped. Is this a characteristic of the basic design or is it a 
symptom of something else?

Thanks - Dan


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>