Sometimes knowledge from the past is forgotten.
Please refer to Bill Orr's Radio Handbook. I am looking at 1970 18th
Edition, page 436, DC Relay Operation. Bill states that an AC relay will
operate without damage at a DC voltage of about 70% of its rated AC. I
fully agree as I have been using AC relays with DC in this manner for years
in amplifiers and other applications and never have had a problem.
David
KC2JD
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com]On
Behalf Of Rich
Sent: Monday, January 30, 2006 12:53 PM
To: Amps
Subject: Re: [Amps] AC to DC
Message: 1
Date: Sun, 29 Jan 2006 17:46:58 -0500
From: John Popelish <jpopelish@rica.net>
Subject: Re: [Amps] AC to DC
To: Amps@contesting.com
Gary Schafer wrote:
> Yes, but my point is that an AC relay operated on DC with the DC
> voltage the same as the AC voltage rating, the relay may overheat.
Sorry, I missed what you you were implying. Of course, any AC relay
will pull in with a DC voltage lower than its rated AC voltage, and
will almost certainly overheat if operated with DC voltage equal to
its rated AC voltage.
Rich ,kd0zz here , I asked the original question. I have limited cash
amount and trying to build an amp with what I have on hand. I have a
several Potter/Brumfield and other brands DPDT 10amp relays with 120v ac
coil, most octal base, some lugs.
When used in the R/F input/output my thought was that AC coil might
induce hum and could these be used at a different DC voltage.
Making a DC supply from stock on hand would be free, buying new relays
is not.
Thanks for any input as some already have , sorry for the confusion.
Rich , kd0zz
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|