Bill Turner wrote:
> At 09:09 PM 12/14/2005, Tom Cathey wrote:
>
>
>>It was pointed out to me that the cathode resistor for negative feedback is
>>to be used only for a grid driven [grounded cathode] amplifier to generate
>>degenerative [negative] feedback.
>
>
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>
> This is a question I've often wondered about.
>
> Does a cathode resistor in a grid-driven amp actually produce
> negative feedback, or does it merely reduce the gain?
>
> My understanding is that for true negative feedback, some of the
> output must be fed back to the input out of phase. In the case of the
> cathode resistor this does not seem to be happening. In fact, the
> output could have a wide variation in gain without affecting the
> input circuit at all. As an extreme example, suppose the plate load
> circuit dropped to a very low impedance for some reason. With true
> negative feedback, the circuit would automatically compensate and the
> output would remain the same (within the capabilities of the feedback
> loop of course). With only a cathode resistor, the output would fall
> and no compensation would occur. To me, this does not sound like true
> negative feedback.
>
> Is this correct?
>
> 73, Bill W6WRT
An unbypassed cathode resistor in a grid driven amp does in fact provide
negative feedback. It is often done in audio amplifiers to improve
distortion.
As the grid is driven positive the plate voltage goes negative because
of increased plate current. With increased plate current the cathode
voltage goes positive because of the resistor. The higher you allow the
cathode voltage to rise the more it counters the grid drive. In other
words the positive cathode voltage reduces plate current.
This is a direct feedback method that is out of phase with the input as
required for negative feedback.
As far as automatically compensating for plate loading, it will to some
extent depending on the amount of feedback selected.
In your example of plate load dropping to a lower value, that would
normally allow more current to be developed in the plate circuit which
would produce more output.
But with the cathode resistor in place the cathode voltage rise will be
greater in this situation which will develop more feedback voltage at
the cathode because of the greater cathode current which reduces plate
current (because the grid to cathode voltage is being biased negative)
which reduces output. All this happens in real time.
If you use enough feedback the output could remain nearly constant
regardless of plate load applied but overall stage gain would be quite low.
73
Gary K4FMX
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|