Hello Stan,
Yes I have tried it into a dummy load and the loading is the same. I
run resonant antennas on both 80 & 40 so I don't think that's the
problem either.
Monday, September 19, 2005, 10:04:25 PM, you wrote:
SS> Did you try it into a 50 ohm dummy load and see if you got the same results?
SS> If it works on the dummy load, then check the antennas with an analyzer and
SS> see what they look like.
SS> Stan
SS> ----- Original Message -----
SS> From: "John Parkins" <kvp@bigfoot.com>
SS> To: "Amps Listserver (contesting.com)" <amps@contesting.com>
SS> Sent: Monday, September 19, 2005 3:34 PM
SS> Subject: [Amps] SB200 loading problem
>> Hello All,
>>
>> The loading control on my SB200 is hard over anti-clockwise, i.e. max
>> capacity on both 80&40 so I can't ever tune through a peak as such.
>> Any ideas why this might be or what I can do to to get round the
>> problem?
>>
>> I wonder if another user could let me know where their control is set
>> for these two bands mainly to see if this is a general problem.
>>
>>
>>
>> --
>> Best regards,
>> John G8KVP mailto:kvp@bigfoot.com
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
--
Best regards,
John mailto:kvp@bigfoot.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|