Amps
[Top] [All Lists]

[Amps] L-4B Switch

To: amps@contesting.com
Subject: [Amps] L-4B Switch
From: Marv Gonsior <w6frmarv@dslextreme.com>
Date: Mon, 05 Sep 2005 11:06:18 -0700
List-post: <mailto:amps@contesting.com>
Greetings,

To all those who who contacted me, I am sorry to report that there does not 
appear to be a replacement for the errant power switch.   The consensus is 
that the root cause of the failures is the probable high inrush current to 
the power transformer so anything that can be done to limit it will 
alleviate the problem.  It was suggested that an external switch be used 
while leaving the switch in the "ON" position.  Another suggestion was to 
spray the switch with WD-40, work it about 30 times and let it sit for a 
few hours thereafter.  This worked for Fred, K2GKM.  This switch is also 
used in the L-7 so junker parts, in either case, could be a 
source.  Another suggestion was to rewire the switch, incorporate a small, 
1/3 ohm current limiting resistor connected to the low voltage side of the 
switch so you would start in that position and then switch to the high 
voltage position for operating.

73,

Marv, W6FR


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>