Transorbs. Tell me which MOSFET and I'll tell you which transorb to use.
Sincerely,
Dr. William J. Schmidt, II K9HZ
Trustee of the North American QRO - Central Division Club - K9ZC
Email: bill@wjschmidt.com
WebPage: www.wjschmidt.com
"If computers get too powerful, we can organize them into a committee; that
will do them in." -- Bradley's Bromide
----- Original Message -----
From: "Borislav Trifonov" <bdt@shaw.ca>
To: <amps@contesting.com>
Sent: Sunday, June 05, 2005 7:39 PM
Subject: [Amps] overvoltage
> How do I overvoltage protect a MOSFET? I tried those gas discharge
> arrestors, but they don't cut off fast enough after they ignite. MOVs
> are too slow, and avalanche diodes can't take much dissipation. I'm
> using the MOSFETs to switch AC signals, and inductive loads make voltage
> spikes, so occasionally it fries a MOSFET.
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|