Re: [Amps] Air Gap

["Will Matney" <craxd1@ezwv.com>]

Rich,

I think you'll find a lot of useful information over on the Oren Elliott  
website. Their URL is below.

OE:   http://www.orenelliottproducts.com/

Will



On Mon, 17 Jan 2005 18:34:59 -0600, Rich <rdjmgmt@socket.net> wrote:

> I am getting parts together for my first amp. I have 3, 4-1000a tubes
> ,chimneys ,sockets and fil transformers . I plan on a single tube amp
> for my first try , it will be for 15 and 20 meters. The power supply is
> good for 0 to about 5000v. I am building the plate variable cap now ,
> the first try is one with .200 gap between the plate and rotor. This gap
> can be changed with out much problem until I put it together for the
> last time. I was thinking about a .400 gap. I looked for a chart to
> figure the gap required with but did not find one. I will max out at
> about 4500v  but I could run less if needed.
> Rich
> KD0ZZ
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> __________ NOD32 1.880 (20040928) Information __________
>
> This message was checked by NOD32 antivirus system.
> http://www.nod32.com



--
Using Opera's revolutionary e-mail client: http://www.opera.com/mail/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps