But, if you are only operating CW or FSK it is not needed. Due to the fact that
intermodulation distortion is not an issue. You can operate class C. The only
need for some ( very little) linearity only to prevent key clicks. If you used
a very nonlinear amplifier such as class E key clicks will be produced when
using OOK or CW. That is why for CW they modulate the power supply. It softens
the turn on and off.
73
Bill wa4lav
-----Original Message-----
From: "Phil Clements" <philk5pc@tyler.net>
To: <dezrat1242@ispwest.com>, <amps@contesting.com>
Date: Fri, 8 Oct 2004 18:27:34 -0500
Subject: Re: [Amps] Need for input tuning circuit
> Consider a grounded-grid 8877 HF amplifier.
>
> I understand the need for an input tuning circuit to maintain
> linearity operating SSB, but what if the operation is CW or RTTY?
> What if the 8877 is driven directly from the transceiver's output,
> using the built-in antenna tuner for impedance matching? Are there
> any drawbacks I'm not seeing?
Two reasons for a tuned input circuit mounted near the tube(s):
Input waveform distortion occurs as a result of grid and plate current
loading of the input circuit on alternate half-cycles by the
single-ended driver stage. the driving source sees a very low value of
load impedance over a portion of the RF cycle and an extremely high
impedance over the remaining portion of the cycle. Unless the output
voltage regulation of the wave on the loaded part of the cycle in the
grounded-grid stage will act to preserve a distorted waveform. A tuned
cathode circuit with a Q of 2 or more, and resonated to the operating
frequency will do the job of preventing this distortion.
A tuned cathode circuit provides a very short RF return path for plate
current pulses from plate to cathode. When a tuned circuit is not
used, the RF return path is via the outer shield of the of the coaxial
line, through the tank circuit of the exciter or tuner, and back to
the cathode of the linear amplifier tube via the center conductor of
the coaxial line. This random, uncontrolled path varies with the
length of interconnecting coaxial line, and permits the outer shield
of the line to be "hot" compared to RF ground.
These words are not mine, they are Bill Orr's.
(((73)))
Phil, K5PC
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|