Use them , but make sure they are phased properly or the voltage will be too
low.!!!
carl / kz5ca
----- Original Message -----
From: "David C. Hallam" <dhallam@rapidsys.com>
To: <amps@contesting.com>
Sent: Sunday, June 20, 2004 10:50 AM
Subject: [Amps] Filament Transformer
> I am building a linear using a 4CX1500A that needs about 38 amps at 5
volts
> for the filament. I have two identical 5V 21A filament transformers. Is
> there any reason why I can't wire the two in parallel to get the required
> amperage the filament? I would put a current inrush limiter for a soft
> start.
>
> David C. Hallam KC2JD
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|