Hello everyone,
I'm looking for one of the small Henry Roller Coils for a project.
I don't believe that they carry any ID info but, they measure as
follows:
The end plates are 4" x 4.5"
The unit is 6" long overall.
The coil is 3" OD and is wound with 21 turns of 1/4" wide flat wire
and I think that they are 18uH.
Anyone have one laying around?
73 & Good morning,
Marv WC6W 310 649 3111
*
________________________________________________________________
The best thing to hit the Internet in years - Juno SpeedBand!
Surf the Web up to FIVE TIMES FASTER!
Only $14.95/ month - visit www.juno.com to sign up today!
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|