[Amps] Swan Mark 1 Plate current fixed!!

[Bill Smith <ko4nrbs@yahoo.com>]

The 1K ohm 1% resistor in the voltage divider had
dropped to less than 450ohms for some reason. 
Replaced it and now all is well.

The resting plate voltage as measured with a Fluke HV
probe is 2950vdc SSB mode and 1550vdc CW mode.

Thanks for all the helpful hints!!
73,
Bill

=====
Bill Smith KO4NR

__________________________________
Do you Yahoo!?
New Yahoo! Photos - easier uploading and sharing.
http://photos.yahoo.com/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps