Amps
[Top] [All Lists]

RE: [Amps] 220V service for amplifier

To: "Joe Isabella" <n3ji@yahoo.com>, "Amps" <amps@contesting.com>
Subject: RE: [Amps] 220V service for amplifier
From: R.Measures <r@somis.org>
Date: Fri, 5 Dec 2003 18:24:59 -0800
List-post: <mailto:amps@contesting.com>

>Sure, but I notice that the tuning is quite different and I don't tear up 
>my security system,
>garage door opener, or phones as bad with the amp grounded.  

**  please describe your antenna and feedline.  Tnx

>I also don't 
>get RF into my audio
>gear with everything well grounded.
>
>Joe,
>N3JI
>
>--- "R. Measures" <r@somis.org> wrote:
>> >
>> **  I conducted a number of signal strength measurements on 40m using a 
>> balanced antenna, and no difference was observed on Tx (at the Rx end) or 
>> Rx at this end with or without the good RF ground.  Also, the SWR did not 
>> change with or without the RF ground.  
>
>
>__________________________________
>Do you Yahoo!?
>Free Pop-Up Blocker - Get it now
>http://companion.yahoo.com/
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>