Jim, what component does the shaft drive? I have a bunch of various small
variable caps. If I have something that you can use, I will send it to you.
I have welded steel shafts and gotten them pretty close. I used MIG with
0.023 wire, ground both ends smaller first and applied several short tack
welds with quick cooling after each to protect the component. After I built
it up, I ground it smooth. Like I say..."pretty close". If you can clamp it
in any way, you can get it even closer.
73,
Jeff - K1LE - CT ><>
----- Original Message -----
From: "Jim Isbell" <millenniumfalcon@cableone.net>
To: "Roger D. Johnson" <n1rj~@pivot.net>; <amps@contesting.com>
Sent: Wednesday, July 02, 2003 9:44 AM
Subject: Re: [Amps] Preparation for Amp construction
> Then, "Measurements" is the name of the company??? Yes, it is the model
59
>
> I think if I smooth off the end of the shaft and drill a small hole in
> it to accept a screw "stud" and then put another short piece of shaft,
> similarly drilled, on the end with some JB weld, it should do the job.
> The second option is to cut a short section out of the cover to expose
> a place where I can use the disk as a thumb wheel, that will work. That
> is how I tested it .... with the cover off.
>
> Roger D. Johnson wrote:
>
> > Hi Jim....
> >
> > It sounds very much like a Measurements model 59. It
> > has the power supply and meter in one case and the
> > oscillator and dial assembly in the measuring head.
> > There is a manual on BAMA under Boonton. A nice unit
> > but repairing the broken shaft on the tuning cap will
> > be tricky. I've never had much luck repairing those
> > old fiber shafts. Perhaps someone on the group will
> > have a sure-fire way.
> >
> > 73, Roger
> >
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
To: <amps@contesting.com>
Version: 6.0.495 / Virus Database: 294 - Release Date: 6/30/2003
|