Then, "Measurements" is the name of the company??? Yes, it is the model 59
I think if I smooth off the end of the shaft and drill a small hole in
it to accept a screw "stud" and then put another short piece of shaft,
similarly drilled, on the end with some JB weld, it should do the job.
The second option is to cut a short section out of the cover to expose
a place where I can use the disk as a thumb wheel, that will work. That
is how I tested it .... with the cover off.
Roger D. Johnson wrote:
> Hi Jim....
>
> It sounds very much like a Measurements model 59. It
> has the power supply and meter in one case and the
> oscillator and dial assembly in the measuring head.
> There is a manual on BAMA under Boonton. A nice unit
> but repairing the broken shaft on the tuning cap will
> be tricky. I've never had much luck repairing those
> old fiber shafts. Perhaps someone on the group will
> have a sure-fire way.
>
> 73, Roger
>
|