>I am building a 4-1000A linear and will have 4KV on the anode. What is
>the MINIMUM clearance I must have from the anode to the top of the metal
>cabinet? It looks like it will be about 1" in my present configuration.
> Will that be sufficient to prevent any problems?
? The max-signal peak-V on the anode is a bit less than double the anode
supply V, or, in this case, a tad under 8kV. In dry air, 8kV can jump about
0.31" or 7.8mm.
>I am looking for a chassis 14"x13.25"x3.25".........may have to go to a
>shorter one if the answer to above question is NO but really need the
>3.25" for the input tuning box to fit.
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
Rich, AG6K, 805-386-3734, www.vcnet.com/measures
|