You might try a 1N3306B from R.F. Parts: 7.5V, 50W stud mount, $13.95/each.
WB2WIK/6
"Success is the ability to go from failure to failure with no loss of
enthusiasm." -Winston Churchill
> -----Original Message-----
> From: ke5c [SMTP:ke5c@hot.rr.com]
> Sent: Monday, January 27, 2003 4:31 PM
> To: amps@contesting.com
> Subject: [Amps] HELP: obsolete power zener for a TL-922
>
> Does anyone know of a source for power zeners? I lost the bias zener in
> an
> old Kenwood TL-922. It's 7.2 volts at unknow watts, but it carries both
> grid and plate current which could total near an amp, so it's likely at
> least a 10 watt device - and it looks it. Kenwood says it's discontinued,
> and it's replacement, a "ZX7.5" is $49.70, and I'm hoping to find a less
> expensive solution. It failed when a 160 volt electrolytic blew up and
> spewed foil around the base of the control transformer, and I think the
> zener got a dose of 110 v to ground - the amp was sitting in idle mode at
> the time. Thanks for any suggestions.
>
> 73, John, ke5c@arrl.net
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
|